Cadac 193E - Troubleshooting; Cleaning; Storage

44
Item Spare No.
Jet 0.60
(Pilot burner)
SP193E-1
Jet 0.8
(Dual ring burner)
SP193E-2
7. Troubleshooting
• A normal ame is blue and may have a yellow tip. If the ame is completely yellow, it may be that the jet is not securely tted. Re-
tighten the jet to give a gas tight seal. An overlled gas cylinder can also cause large yellow ames. Cylinder should be returned to
lling station and checked by weight.
• Check that the inlet to the burner pipe is clear and free of obstructions.
• If the ame power drops or the gas will not light, check that the gas cylinder still contains gas (shake to hear the noise made by the
liqueed gas). If there is still gas, the jet might have become blocked or partially blocked.
• If you suspect a blocked jet, follow the instructions above.
• Check for spider webs or insect nests in the gas tube or primary air inlet.
GB
8. Cleaning
• It is recommended to clean your appliance after every use. This will prolong the life of your appliance.
• The pot stand is removed by lifting it from the stove top and can be washed in a detergent solution.
• To clean the stove body, simply wipe with a damp cloth using a little detergent, if necessary.
• DO NOT IMMERSE IN WATER as this will allow water to get into the burner tube causing the appliance to malfunction.
• Do not use abrasive cleaners or scourers as this will cause permanent damage to the surface.
• To avoid ignition failure, keep the burners clean.
• Use a brush to clean the burners.
9. Storage
• Handle the appliance with care. Do not drop it.
• After use, wait until the appliance has cooled down, disconnect it from the gas cylinder and store them in a cool dry place. Store your
cylinder in a well-ventilated place.
• It helps to place the appliance in a plastic bag when not in use as this will prevent the ingress of dirt and insects, which may affect
the gas ow.
• Warning: An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
• LPG cylinders should preferrably be stored outdoors if not in use.
10. Spares
• Always use genuine CADAC spares as they have been designed to give optimum performance.
11. Returning the Appliance for Repair or Service
• Do not modify the appliance. Any modication of the appliance may be dangerous.
• Any modications will render the CADAC warranty null and void.
• If you cannot rectify any fault by following these instructions, contact your local CADAC distributor for inspection/repair
• Unscrew the blocked jet from the valve with a suitable spanner and replace it with a new jet.
• Do not over tighten as this may damage the jet. To re-assemble, reverse the above procedure.
• Do not use pliers on the jet as this may damage the jet making it unusable or impossible to remove.