Compass Calibration
Once the comp&
is
calibrated, it does not need to be
recalibrated.
To
calibrate
the
compass:
1.
Set the switch on the mirror control to
C/M.
2.
Turn
the vehicle ignition switch on. The letter
C
should be displayed in the mirror compass window.
If
not, hold the
CAL
switch (on the bottom
of
the
mirror) for more than
10
seconds, and the letter
C
will appear. To hold in the
CAL
switch, insert a
paper clip into the small hole on the bottom
of
the
mirror housing. The display will show a number
first, but keep holding until the letter
C
appears.
360-degree circle at less than
5
mph
(8
km/h)
until
the display reads a compass direction. For normal
calibration, drive the vehicle
on
your everyday
routine, and the compass will eventually calibrate.
3.
For quick calibration, drive the vehicle in
a
Compass Variance
To Next Page
Loading...
