laying
8
Caslsette
With the radio on, insert a cassette tape. The tape will
begin playing as soon as it is inserted.
While the tape is playing, use the
VOL,
FADE,
BAL,
BASS
and
TREB
controls just as you do for the radio.
Other controls may have different functions when a tape
is inserted. The display will show
TAPE
with an
arrow
to indicate which side
of
the tape
is
playing. PLAY will
appear on
the
display temporarily when
a
tape
is
playing. The display will then revert back
to
showing
the
time.
If
an error occurs while trying to play a cassette tape, it
could be that:
8
The cassette tape is tight and the cassette player
cannot
turn
the
hubs
of
the tape. Hold
the
cassette
tape with the open end down and
try
turning
the
right
hub counterclockwise with a pencil. Flip the tape
over and repeat.
If
the hubs do not
turn
easily, your
cassette tape may be damaged and should not be
used in the player. Try
a
new tape to be sure your
player
is
working properly.
The cassette tape
is
broken. (Check to see if your
tape is broken. Try a new tape.)
Press
the left arrow to reverse the tape rapidly.
Press
it
again to return to playing speed.
The
radio will
play while the tape reverses and
REV
will appear on the
display. You may use your station pushbuttons to
tune
to
another radio station while
in
REV
mode.
FF:
Press the right
arrow
to fast forward to another part
of
the tape. Press
it
again to return
to
playing speed. The
radio will play while the tape advances and
FF
will
appear on
the
display. You may
use
your station
pushbuttons to
tuie
to
another radio station while
in
FF
mode.
SEEK-TUNE:
Press the right arrow
to
seek
to
the next
selection on the tape. Press the left
arrow
to search for
the
previous selection on the tape
(REP
will appear on
the
display). Your tape must have at least
three
seconds
of
silence between each selection for
SEEK-TUNE
to
work. The sound will mute while seeking.
SCAN:
Press this button. SCAN
IT
will appear on the
display until the next selection is found and then
SCAN
PLAY will appear
on
the display. Use SCAN to listen to
selections for
a
few seconds. The tape will
go
to
a
selection, stop for
a
few seconds, then
go
on to the next
selection. Press this button
again
to
stop scanning.
that
is
playing.
(PLAY shows on the display.)
E:
Press this button to change
the
side
of
the
tape
3-
To Next Page
Loading...
