SOURCE:
Press this button
to
switch from radio to
cassette tape play.
If
no
cassette tape
is
in
the tape
player,
CASS
appears on the display and then the radio
station appears briefly. The display then reverts back
to
showing the
time
of
day. Press this button again
or
BAND
to switch back to the radio.
6
EJECT:
Press the upward triangle button to
remove a tape. The radio will play. Eject may be
activated with the radio
off.
Cassette tapes may be
loaded with the radio
off
but they will not start playing
until the
PWR
button
is
pressed. Press
PWR
or
turn
the
ignition key
off
to stop the cassette tape player. The tape
will stay
in
the player and resume play at the point
where
it
stopped. If you leave a cassette tape
in
the
player while listening to the radio, it may become warm.
CLN:
If this message appears
on
the display, the
cassette tape player needs to
be
cleaned. It will still play
tapes, but
you
should clean
it
as soon as possible to
prevent damage to the tapes and player.
See
“Care
of
Your Cassette Tape Player” in the Index. After
YOU
clean
the player, press and
hold
EJECT for five seconds
to
reset the
CLN
indicator. The radio will display
---
to
show the indicator was reset.
Dolby@ Noise Reduction
is
manufactured under
a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
e
For information
on
the
compact disc player, see “Trunk
Mounted
CD
Changer” later
in
this section.
Playing
the
Radio
OL:
Press
this
knob
lightly to release
it
from
its
stored position. The system
will
turn
on.
Press
the
knob
again to
turn
the system
~ff.
To
increase volume,
turn
the
knob
clockwise.
Turn
it
counterclockwise to decrease
volume. The volume level
will
appear on the display.
To Next Page
Loading...
