Finding
8
Station
BAND:
Press this button to select
AM,
FMl
or
FM2
and preset stations.
SEEK-TUNE:
Press and release
ths
button to seek to
the
next higher or lower radio station. Pressing and
holding
this
button until a chime sounds puts the radio in
a
tune
mode.
In
this mode, higher or lower radio stations
are advanced to in small increments until the
SEEK-'FUNE
button is released. Tuning stops when
you
release this button.
If
you press and hold the
SEEK-TUNE
button again within five seconds
of
being
in the tune mode, tuning will continue. Waiting longer
than
five seconds places the radio back
in
the seek mode.
SCAN:
Press this button and
SCAN
will appear on
the
display.
Use
SCAN
to listen to stations for
a
few
seconds.
The
radio will
go
to
a station, stop for
a
few
seconds, then
go
on to the next station. Press this button
again to stop scanning.
PUSHBUTTONS:
The
six
numbered pushbuttons let
you return to your favorite stations. You can set up to
18
stations (six
AM,
six
FM1
and six
FM2).
Just:
1.
2.
3.
4.
5.
Turn
the radio on.
Press
BAND
to select
AM,
FM1
or
FM2.
Tune in
the
desired station.
Press and hold one
of
the
six numbered buttons until
you
hear a chime.
A
preset number will appear on
the display. The sound will mute. When
it
returns,
release the button. Whenever you press that
numbered button,
the
station
you
set will return.
Repeat
the
steps for each pushbutton.
PRESET
SCAN:
Press
and hold
SCAN
for
two
to
three
seconds until
PRESET
SCAN
appears on the display to
listen to each
of
your preset stations for
a
few seconds
(factory presets which have not been reprogrammed
with your stations will be ignored). The radio will
go
to
the first preset station stored on your pushbuttons, stop
for
a
few seconds, then go on to the next preset station.
Press
SCAN
again to stop scanning.
If
a
preset station
has weak reception, the radio will
not
stop at
the
preset station.
To Next Page
Loading...
