The
lumbar
control is
located
on
the outboard side
of
each front seat. It
provides additional support
to
your lower back and it
works independently of the
other seat controls.
Use
the
power seat control first to
get
the
proper position.
Then proceed with the
Bumbar adjustment.
Adjust
the
driver’s seat
(including lumbar
adjustments) and both
outside mirrors to a
comfortable position
and
then press the
SET
button.
Within
five
seconds,
To
reshape the lower seatback, press the lumbar control
forward to increase support and rearward
to
decrease
support. Press the control
up
or
down
to
raise or lower
the
support mechanism.
Keep in mind that as pur seating position changes,
as
it
may during
long
trips,
so
should
the position
of
your
lumbar
support. Adjust the
seat
as needed.
If
you have
the
optional personalization package,
the
power lumbar control can be programmed for memory
recall.
FQ~
more information, see “Memory Seat and
Mirrors” later
in
this
section.
A
second mirror and seating position
may
be
programmed by repeating
the
above steps and pressing
button
“2,’
instead
of
button
1.
Note
that each time
a
memory button is pressed,
a
single beep will sound
through the left front speaker.
If
your vehcle is
in
PARK
(B),
you
can
redl &or
and
seatirag positions
by
briefly pressing button
1
or
2.
This
will
adjust the seat
and
mirrors to where you have
previously programmed
them.
If
you have accidentally
pressed one
of
the
memory
recall buttons and want
to
stop
seat
or
mirror movement, press one
of
the manual seat or
mirror
control
buttons.
Th~s
cancels
a
memory recall.
To Next Page
Loading...
