When you press this symbol to unlock
the
driver’s door, the parking lamps on your vehicle will
blink twice. (You can program your vehicle
so
the
parking
lamps will not flash. For more information,
see “Remote Confirmation” later
in
this section.)
Pressing it again within five seconds will unlock the
other doors. Pressing this button will also disarm
the
optional theft-deterrent system and turn on the interior
lamps at night.
When you press
this
symbol to lock the
doors,
the
parking
lamps
will
blink
once. (You can program
your
vehicle
so
the
parking
lamps
will not flash. For more
information,
see
“Remote Confirmation” later
in
this
section.)
This
also
arms
the optional theft-deterrent system
when the ignition
is
off.
Press this symbol
to
open the trunk.
Press ths button to open the fuel door.
The
pu(E
transmitter can
also
be used to recall. the
memory settings for up
to
two
drivers. For more
information, see “Memory Seat
and
Mirrors”
in
the
Index.
Note that pressing the transmitter buttons numerous times
(approximately
500
times) out
of
the
vehicle‘s operating
range may cause the transmitter not
to
work.
Replacing
the
battery and pressing
the
transmitter buttons
10
or
more times out
of
range
will
also cause the transmitter
not
to
work.
To
reset
the
transmitter, you must be within
the
vehicle’s operating range. Press and hold the
trunk
button, and within
one
second, press and
hold
the lock
button. Continue
to
hold both buttons for approximately
three seconds. See your Cadillac dealer for service if your
transmitter still doesn’t work properly.
This personalization feature allows the driver to program
the
parlung lamps to blink or
to
remain
off
when the lock
or
unlock buttons
om
the
RISE
transmitter are pressed.
Press the
SET
(TIRIIP
RESET)
button
to
answer
“yes,” press the
WESET’
(INFO
RESET)
button
to
indicate “no” or press the INFORMATION
(INFO)
button
to
“skip”
to the
next
personalization feature.
To
begin programming, press the unlock button of
the
RKE
transmitter for the appropriate driver
(1
or
2).
The ignition must be
in
the
RUN
position. Press and
hold the
INFORMATION
(INFO)
and
RESET
(INFO
RESET)
buttons at
the
same time. The first message to
appear refers to
the
programmable automatic door locks.
To
skip
this prompt, press the
‘I[NFQWMATION
(INFO)
button.
To Next Page
Loading...
