When
REMOTE
FLASH
LIGHTS
appears on the
DIC
display, press the yes button
to
program the parking
lamps to blink once when the lock button on the
RKE
transmitter
is
pressed and
to
blink twice when the
unlock button
is
pressed.
If
you don’t want the
parking
lamps
to
blink when using the
RKE
transmitter, press
the no button.
FEATURE
ON will display
if
REMOTE
FLASH
LIGHTS
was selected and
FEATURE
OFF
will
show
if
you answer no.
For a list of the other personalization features available,
see “Memory and Personalization Features” later in
this section.
This personalization feature enables the driver to
program the exterior lamps to
turn
on
for
20
seconds
or
to
remain
off
when using the
RKE
transmitter
to
unlock your vehicle.
If
exterior lighting is selected, the
parking
lamps,
taillamps,
sidemarker lamps, license plate
lamps,
low-beam headlamps, etc. will
turn
on
for
about
20
seconds or until the ignition
key
is
turned to
RUN.
Check
the
back
of
the
RKE
transmitter to verify that the
correct driver is selected before you start programming.
To
begin programming, press the INFORMATION
(INFO)
and
RESET
(INFO
RESET)
buttons at the
same
time for about
two
seconds. Exterior fighting
is
the
third
feature to
display.
Press the WOWMATION
(INFO)
button
to
“skip” past the first two features
--
DOOR
LOCKS
IN
GEAR
and
REMOTE
FLASH
LIGHTS.
When
EXT
LIGHTS
AT UNLOCK
appears,
a
“yes” or
“no” response
is
required. Press the
TRIP
SET
(TRIP
RESET)
button
to
answer yes or press the
RESET
(INFO
RESET)
button
to
indicate
a
no
response.
FEATURE
ON
displays when
a
yes
response
is
made
and
FEATURE
OFF
shows after a
no
response.
For a list of the other personalization features available,
see
“Memory
and Personalization Features” later in
this section.
Your vehicle
may
have memory personalization.
If
it
does,
REMOTE
RECALL
MEMORY
will
be
the fourth
personalization feature to display on the
DIC
system.
Memory settings that
have
been
previously programmed
(HVAC
settings, radio preset settings, exterior lighting
choices, remote confirmation choices and programmable
automatic
door
1oc.k
choices) can
be
recalled by using
either the
RICE
transmitter or
by
placing the key
in
your
vehicle’s ignition.
To Next Page
Loading...
