To
begin programming, check the back
of
the
RKE
transmitter to verify that
the
correct driver is selected.
Press the
INFORMATION
(INFO)
and
RESET
(INFO
RESET)
buttons at
the
same time for about two seconds.
As
mentioned, memory recall
is
the fourth feature
to
appear.
To
“skip”
past
the first
three
personalization
features, press the
INFORMATION
(INFO)
button.
When
REMOTE
RECALL
MEMORY
appears, the
driver is able to recall memory settings when
the
unlock
button on the
RKE
transmitter is pressed with the
ignition in
LOCK.
Press
the
TRIP
SET
(TRIP
RESET)
button to select or press the
RESET
(INFO
RESET)
button to answer
no
and to continue on to
the
next
prompt.
(FEATURE
ON
displays when a yes response
is
made and
FEATURE
OFF
shows when a
no
response
is made.)
If
a no response was made, the
KEY
IN
RECALL
MEMORY
prompt will show next. This choice recalls
memory settings when the key is placed
in
your
vehicle’s ignition.
A
yes or no response is required.
For a list
of
the other personalization features available,
see “Memory and Personalization Features” later
in
this section.
Each
RKE
transmitter is coded to prevent another
transmitter from unlocking your vehicle. If
a
transmitter
is lost or stolen,
a
replacement can
be
purchased through
your dealer. Once your dealer has coded the new
transmitter, the lost transmitter will
not
unlock your
vehicle. Each vehicle can have only two transmitters
matched to it.
Under
normal
use, the battery in your
RKE
transmitter
should Bast about four years.
You
can tell
the
battery
is
weak
if
the transmitter won’t
work at the normal range in any location.
If
you have to
get close
to
your vehicle before the transmitter works,
it’s probably time to change the battery.
When
replacing the battery,
use
care
not
to
touch
any
of
the
circuitry.
Static
from
your
body
transferred
to
these
surfaces
may
damage
To Next Page
Loading...
