1-37
The safety belt locks if there’s a sudden stop or a crash,
or if you pull the belt very quickly out of the retractor.
The rear outboard seating positions may have a shoulder
belt tightness adjustment feature. You can tell if your
vehicle has this feature by following the steps below. If
you can add a small amount of slack, your vehicle has
this feature.
If the shoulder belt seems too tight:
1. Sit well back in the seat.
2. Pull the shoulder belt all the way out of the retractor.
3. Let belt go back all the way.
4. Now you can add a small amount of slack. Lean
forward slightly, then sit back. If you’ve added more
than 1 inch (25 mm) of slack, pull the shoulder belt
out as you did before and start again.
If you move around in the vehicle enough or if you pull
out the shoulder belt, the belt will become tight again. If
this happens, you can reset it.
To Next Page
Loading...
