2-11
3. Replace the battery. Insert the new battery as the
instructions under the cover indicate.
4. Snap the transmitter back together tightly to be sure
no moisture can enter.
5. Resynchronize the transmitter. See
“Resynchronization” following.
Resynchronization
Pressing the remote keyless entry transmitter buttons
numerous times (approximately 250 times) out of
the vehicle’s operating range may cause the transmitter
not to work. Replacing the battery and pressing the
transmitter buttons out of range will also cause the
transmitter not to work. If only the instant alarm button
works, the transmitter needs to be resynchronized to the
receiver. Do this by pressing and holding both the lock
and unlock buttons on the transmitter for about eight
seconds. You must be within range of the vehicle.
Once the transmitter has been resynchronized, the locks
will cycle from lock to unlock. See your dealer for
service if your transmitter doesn’t work properly.
To Next Page
Loading...
Need help?
General
