6-42
3. At the wall or other flat surface, measure from the
floor to the recorded distance and draw a horizontal
line the width of the vehicle.
4. Turn on the low beam headlamps and place a piece of
cardboard or equivalent in front of the headlamp not
being dimed. This should allow the beam cut
-off of the
headlamp being aimed to be seen on the flat surface.
NOTICE:
Do not cover a headlamp to improve beam
cut
-off when diming. Covering a headlamp may
cause excessive heat build
-up which may cause
damage to the headlamp.
To Next Page
Loading...
