2. Assemble wheel blocks (A) and jack (E)
together with the wing nut (F).
3. Position the jack (E) and wheel blocks (A)
in the driver’s side trim panel over the
wheelhouse.
4. Turn the wing nut (G) clockwise until the
jack is secured tight in the mounting
bracket. Be sure to position the holes in
the base of the jack onto the pin in the
mounting bracket.
5. Use the retaining bracket (C) to fasten the
tool bag (B) on the stud and turn the wing
nut (D) clockwise to secure.
6. Return the storage tray to its original stored
position.
Regular Wheelbase shown,
Extended Wheelbase similar.
491
To Next Page
Loading...
