Power Lumbar
The power lumbar
controls are located
on the outboard side
of the front seats.
Press the lumbar control forward to increase support
and rearward to decrease support. Press the top
or bottom of the control to raise or lower the support
mechanism.
Keep in mind that as a seating position changes,
as it may during long trips, so should the position
of the lumbar support. Adjust the seat as needed.
Massaging Lumbar
On vehicles with this
feature, the switch is
located on the outboard
side of the front seats
behind the lumbar switch.
Press the switch to turn the massaging lumbar feature
on. The ignition must be on for this feature to work.
The massage cycle will run for up to 10 minutes.
To stop massage, press the massaging lumbar
switch again or press the power lumbar switch.
1-4
To Next Page
Loading...
Need help?
General
