10-78 Vehicle Care
8. Tilt the tire toward the
vehicle with some slack in
the cable to access the tire/
wheel retainer (G). Separate
the retainer from the guide pin
by sliding the retainer up the
pin while pressing down on the
latch.
Once the retainer is separated
from the pin, tilt the retainer and
pull it through the center of the
wheel along with the cable and
latch.
9. Put the spare tire near the
flat tire.
Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before
proceeding. See If a Tire Goes
Flat on page 10‑73 for more
information.
2. To remove the center cap, place
the chiseled end of the wheel
wrench in the slot on the wheel
and gently pry the cap out.
To Next Page
Loading...
