Keys, Doors, and Windows 2-3
If enabled through the Driver
Information Centre (DIC), the
indicators flash once to indicate
locking has occurred. If enabled
through the DIC, the horn chirps
when
Q is pressed again within
three seconds. See Vehicle
Personalisation on page 5-36 for
additional information.
Pressing
Q arms the content
theft-deterrent system. See Vehicle
Alarm System on page 2-12.
K (Unlock): Press once to unlock
only the driver door. If
K is pressed
again within three seconds, all
remaining doors unlock. The interior
lamps may come on and stay on for
20 seconds or until the ignition is
turned on.
If enabled through the DIC, the
indicators flash twice to indicate
unlocking has occurred. See Vehicle
Personalisation on page 5-36.
If enabled through the DIC, the
exterior lights turn on briefly if it is
dark enough outside. See
“Approach Lighting” under Vehicle
Personalisation on page 5-36.
Pressing
K on the RKE transmitter
disarms the content theft-deterrent
system. See Vehicle Alarm System
on page 2-12.
/ (Remote Vehicle Start): For
vehicles with this feature, press
/
to start the engine from outside the
vehicle using the RKE transmitter.
See Remote Vehicle Start on
page 2-4 for additional information.
8 (Power Tailgate): Press and
hold to open and close the tailgate.
The tail lamps flash and a chime
sounds to indicate when the tailgate
is opening and closing.
m (Liftglass): Press and hold to
open the liftglass.
L (Vehicle Locator/Panic
Alarm): Press and release to
locate the vehicle. The indicators
flash and the horn sounds three
times.
Press and hold
L for more than
three seconds to activate the panic
alarm. The indicators flash and the
horn sounds repeatedly for
30 seconds. The alarm turns off
when the ignition is moved to ON/
RUN or
L is pressed again. The
ignition must be in LOCK/OFF for
the panic alarm to work.
The vehicle comes with two
transmitters. Each transmitter will
have a number on top of it, “1” or
“2”. These numbers correspond to
the driver of the vehicle. For
example, the memory seat position
for driver 1 will be recalled when
using the transmitter labelled “1”,
if enabled through the DIC. See
Memory Seats on page 3-5 for more
information.
To Next Page
Loading...
