5
ELECTRONIC PRECISION SHIFT
♦
e automatic transmission shi paern is displayed on top of the
shi lever with the selected gear position illuminated in red. e
shi lever always starts in the center position and, aer shiing,
returns to the center position.
Park – Press the buon (A)
on top of the lever to shi
into Park. To shi out of
Park, press and hold the
shi lock buon (B) on
the side of the lever while
selecting the desired gear.
Reverse – Press and hold
the shi lock buon (B)
and move the lever for-
ward completely (pass the detent) to shi into Reverse.
Neutral – Move the lever forward (to the detent) to shi into
Neutral.
Note: The transmission will not stay in Neutral for an extended period. It will
automatically shift into Park.
Drive – Move the lever rearward to shi into Drive.
AUTOMATED CAR WASH MODE
When using an automatic car wash, there are dierent procedures
for placing the transmission in Neutral with the engine on or o,
and if the driver exits the vehicle. Refer to your Owner’s Manual for
each procedure.
See Driving and Operating in your Owner’s Manual.
TAP SHIFT MODE
With the transmission in Drive, pull back on the shi lever to
shi to Manual mode. Pull the le steering wheel paddle to
downshi and the right steering wheel paddle to upshi.
To return to Drive, move the shi lever to Drive or, if equipped
with Electronic Precision Shi
♦
, pull back on the lever again.
To engage in
Temporary Tap Shi
Mode, pull either the
le (downshi) or right
(upshi) steering wheel
paddle without moving
the shi lever. e
transmission will return
to automatic shiing
approximately 7–10
seconds aer the last
manual shi.
See Driving and Operating in your Owner’s Manual.
♦ Optional equipment
A
B