Cadillac CTS/CTS-V Owner Manual - 2011
Vehicle Care 10-39
3. Remove the electrical connector
from the bulb by lifting the two
plastic clips.
4. Remove the bulb socket from
the lamp housing by turning the
bulb socket one-quarter turn
counterclockwise.
5. Pull the old bulb from the lamp
housing keeping the bulb
straight as you pull it out.
6. Install a new bulb.
7. Reinstall the electrical connector
by pushing in the two plastic
clips.
8. Push the bulb socket into the
lamp housing and turn the
socket one‐quarter turn
clockwise.
License Plate Lamp
(Coupe and Sedan)
To replace one of these bulbs:
1. Push the tab to remove the
license plate lamp.
2. Turn the license plate lamp
assembly down to remove it.
3. Turn the socket
counterclockwise and remove it.
4. Pull the bulb straight out to
remove it.
5. Push the new bulb straight into
the socket.
6. Reverse Steps 1 through 3 to
reinstall the license plate lamp
assembly.
License Plate Lamp
(Wagon)
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Wagon)
on page 2‑20
for more
information.
Passenger Side Shown, Driver
Side Similar
2. Push the left end of the lamp
assembly towards the right.
3. Turn the lamp assembly down to
remove it from the liftgate.
To Next Page
Loading...
