1-30 Keys, Doors, and Windows
Programming the Power
Windows
If the battery on the vehicle has
been recharged, disconnected,
or is not working, you will need to
reprogram each front power window
for the express-up feature to work.
Before reprogramming, replace or
recharge the vehicle's battery.
To program each front window,
follow these steps:
1. With the ignition in
ACC/ACCESSORY, ON/RUN,
or when Retained Accessory
Power (RAP) is active, close all
doors.
2. Press and hold the power
window switch until the window
is fully open.
3. Pull the power window switch
up until the window is fully
closed.
4. Continue holding the switch up
for approximately two seconds
after the window is completely
closed.
The window is now reprogrammed.
Repeat the process for the other
windows.
Window Lockout
o (Window Lockout): This feature
prevents the rear passenger
windows from operating, except
from the driver position.
Press
o to activate the rear
window lockout switch. The LED
light comes on when activated.
Press
o again to deactivate the
lockout switch.
To Next Page
Loading...
