2. Pull the seatback
release lever upward
and pull the seatback
up and fold it down until
it is flat. Escalade
lever shown,
Escalade ESV lever
similar.
On the Escalade ESV models, you must first
remove the headrest and store it on the top of the
seat cushion as shown next.
Pull the headrest out from the seatback and slide the
pins into the holes provided in the top of the seat
cushion.
If the seatback cannot fold flat because it interferes with
the cushion, try moving the front seat forward and/or
bringing the front seatback more upright.
Once the seatbacks are folded down, on Escalade ESV
models only, the rear seat footwell area will be
exposed and will have to be covered by the load floor
panel.
1-26
To Next Page
Loading...
