KEYS, DOORS, AND WINDOWS 15
Driver Door Key Lock Cylinder
Access (In Case of Dead Battery)
To access the driver door key lock
cylinder:
1. Pull the door handle (1) to the
open position and hold it open
until the cap removal is complete.
2. Insert the key into the slot (3) on
the bottom of the cap (2) and lift
the key upward.
3. Move the cap (2) rear ward and
remove.
4. Use the key in the cylinder.
To replace the cap:
1. Pull the door handle (1) to the
open position and hold it open
until the cap installation is
complete.
2. Insert the two tabs (6) at the back
of the cap between the seal (5) and
the metal base (4).
3. Slide the cap forward and press the
forward edge to install the cap in
place.
4. Release the door handle.
To Next Page
Loading...
