not be obstructed. The station must not be installed in an airtight area.
Do not install the unit on unstable signs, tripods or table where it could fall. A central
drop can cause physical injury and material damage.
11 / VOLTAGE PEAKS
In case the plant would be subject to accidental voltage peaks, it is advisable to
disconnect the Central sector and the antennas. If these recommendations are
followed, damage spikes, especially during maintenance of the electrical installation or
electrical storms, will be avoided.
12 / FOREIGN OBJECTS
Never insert objects through air vents that may come into contact with live components
or damage components.
13 / REPLACEMENT OF A COMPONENT
When replacing components, make sure that spare parts are compatible with the
specifications of the manufacturer or have the same characteristics as the parts to
replace. The use of components not following these criteria can damage the plant.
Attention:
-The following instructions must be followed to avoid damaging of the mains cable and
the power source:
-The power source or the mains cable must be used outside their normal function. Do
not excessively bend the cable.
-When you disconnect the power cable, hold the cable by taking and not the cable
itself.
-Make sure that the cable is not exposed to any source of heat, which could damage
the insulation material.
-The following instructions must be observed so d ' avoid electric shock
-Do not open the Central
-Do not insert any metal or flammable objects
-Do not touch the connections of the area with wet or damp hands
-If a problem is identified by the use of the Central, disconnect it and contact your dealer
or technician. Continue to use the plant in case of problems can cause damage.
13
To Previous Page
Loading...