Need help?Do you have a question about the CAI 600 Series and is the answer not in the manual?
General| Brand | CAI |
|---|---|
| Model | 600 Series |
| Category | Measuring Instruments |
| Language | English |
Details on performing manual and automatic calibrations.
How to set and manage alarm parameters.
How to change access levels and passwords.
Setting up calibration parameters, including span gas concentration.
Step-by-step process for manual zero and span calibration.
Accessing various setup menus for configuration.
Setting and adjusting measurement range limits.
Modifying system-wide settings like clock and communication.
Describes the flame ionization detection method.
Explains the sample, fuel, and air flow control systems.
Details the connections and components on the rear panel.
Shows the layout of internal components.
Steps for unpacking the analyzer.
Safety warning about electrical hazards.
Information on the correct fuel types for the analyzer.
Detailed description of the Model 600 MHFID analyzer.
Technical specifications of the analyzer.
Recommendations for selecting an installation site and mounting.
List of gases and equipment needed for operation.
Guidelines for making gas connections.
Recommended pressure and flow rates for gases.
Diagram illustrating the main menu hierarchy.
Tree structure for the F5 Setup menu.
Accessing and navigating the measurements menu.
Setting up calibration parameters, including span gas concentration.
Step-by-step process for manual zero and span calibration.
Accessing various setup menus for configuration.
Setting and adjusting measurement range limits.
Modifying system-wide settings like clock and communication.
Step-by-step guide for starting the analyzer.
Steps for safely shutting down the analyzer.
A guide listing symptoms, causes, and remedies.
List of error messages and their meanings.
Definition of absolute deviation.
Definition of measuring deviation.
Details on the RS232 interface and AK commands.
Commands for controlling analyzer functions remotely.
Pin assignments for main and auxiliary connectors.
Pinout for RS-232 serial communication.
New features introduced in later models.
Configuring startup parameters after power loss.
Calibrating analog output signals.
To Next Page
