Control Panel
Troubleshooting:
Electrical Wiring Diagram
Installing The Unit:
swing
water
pump
blue
swing
motor
water
pump
motor
connect to the signal wire
High speed
Low speed
y
ellow
white
brown
N
L
fan
-μF/500V
UV
UV
AC220V~240V
Ultra-low speed
Medium speed
CleaningandMaintenance:
1.TheDryingProcess:For longer lifetimeof your evaporativeaircooler,after usingthe unit, it is
recommended to TURNOFF the coolingfunction (snowflakebutton) and run theunit as a FAN
only for approximately30 mins. This helps to dryout the cooling padsand avoid mildew.The
remaining water canbe kept in the reservoirfor 3 more days,but should be changedat least
once a week. If storingfor longer thanone week, drain the waterfrom the reservoirusing the
drain valve at the bottomof the unit, andthen complete thedrying process.
2.FortheAutomaticDrying: the timer can be used as aconvenience foryou to dry your unit
without having to occupyit. Simply turnthe snowflake buttonOFF,keep the fanrunning, press
the timer buttonon for one hour,and the fan will dry andshut down itself after onehour.
3.The reservoir canhandle 2oz. of bleachin at least 32-gallons ofwater to refreshthe interior.DO
NOT put any othercleaning or foamingproducts into themachine, because it willfoam up the
water and over flowyour unit. Do not dothis more than oncea week.
4.The black screens protectingyour coolingpads will collect dustand should be checkedat least
once a week when usingfrequently.Pullthem out and simplyhose them off orwipe down with a
wet rag and re-insert.Toavoid buildup, DO NOT put chemicalson the screens. Thescreens
should be transparentand you shouldbe able to see completelythrough them afterthey have
been cleaned. Thisensures completeair intake.
5.Cleaningthecoolingpads:makesure the coolingpads are dry andthe machine is unplugged.
Use a screwdriverto removethe back panelof the unit and the coolingpads can easilyslide in
and out. Rinse softlywith a hose throughone side onlyon low pressure and donot use any
chemicals. At an angle,you should be ableto see light thoughthe holes once it hasbeen fully
cleaned.Re-insert the padsgently and putthe back panel back intoplace and put thescrews
back into place.
88
This CAJUN KOOLING the CK3000-S unit is factory tested and ready to use. make sure the unit is
placed on flat level surface and the front casters are locked to prevent inadvertent movement, please
follow the instruction below
1.Stand your box up and remove the box from the unit by lifting it over the top. Make sure that all
parts are intact and correctly assembled.
2.You may begin filling water through the water inlet flap using regular tap water. There is a water
level in the front of your unit, located on the reservoir. Be sure not to fill past the “H”, HIGH, level.
You will not see the water until it reaches half of the tank on “L”, low, but this level may not need to
be reached for your preference. Filling at half of the tank will last at least 4 hours of run time.
3.Plug in the power cord to a safe outlet, and begin using your fan by pressing the Power button.
Choose your suitable speed for your unit and begin enjoying.
2. AUTO WIND MODE
3. COOLING MODE/ WATER PUMP ON/OFF
4. WIND SPEED ADJUSTMENT
5. LCD DISPLAY SCREEN
1. ON/OFF6. TOUCH SCREEN LOCK
7. OSCULATION (SWING) MODE
8. MACHINE SHUT DOWN TIMER
9. REMOTE CONTROL SIGNAL
To Previous Page
Loading...
