Cal Flame BBQ08874CP - Appendix; Troubleshooting

Convection Grills
LTR50001038, Rev. J
Cleaning and Maintenance
www.calamebbq.com
30
1. Remove the screw at the left or right of the lens.
2. Carefully pull the lens away and out of the light
xture. Set the lens, screw clip, and screw aside.
3. Unscrew the two screws located at the side of
the white ceramic light xture.
4. Using a tissue or small piece of paper, pull the
burnt bulb out of the socket.
5. Using a tissue or small piece of paper, carefully
push a new bulb into the socket, making sure
both wires on the bulb go into the light socket
evenly.
6. Tighten the two screws on the side white
ceramic light xture.
7. Replace the light lens by replacing the screw
and screw clip.
WARNING: Never attempt to replace a light bulb when the grill is in use. Serious burns will result.
WARNING: Never touch halogen bulbs with your bare ngers. Use a tissue or a small piece of paper to handle
bulbs. Oils from your hands will damage halogen bulbs.
Cal Flame grills use two different types of light housings. These instructions describe how to change the bulb
in both types.
Light Lens with Screw Clip
Snap-in Light Lens
Light Bulb Replacement
1. Using a small standard screwdriver, carefully
pop out the light lens and set it aside.
2. Using a tissue or small piece of paper, pull the
burnt bulb out of the socket.
3. Using a tissue or small piece of paper, carefully
push a new bulb into the socket, making sure
both wires on the bulb go into the light socket
evenly.
4. Replace the light lens by carefully snapping it
back in place