3
During the inspection it is essential to establish which mounting kit is suitable for the type of heating body on which the heat cost allocator is to
be fitted.
See Table 1 on pages 11-12 to choose the suitable kit.
Example:
- Heat emitter: CAST IRON PLATES
- Distance between the elements: LESS THAN 4 mm
- Mounting kit: code 720060
DD
D
Cast iron plates
720060*
720061*
44
L
Distance between elements (D)
less than or equal to 4 mm
Distance between elements (D)
from 4 to 10 mm
plate (39 mm) + anchor (20 / 39 mm)
plate (39 mm) + anchor (59 mm) + anchor (75 mm)
plate (55 mm) + anchor (20 / 39 mm) + anchor (59 mm)
plate (55 mm) + anchor (75 mm)
plate (88 mm) + anchor (39 mm)
plate (88 mm) + anchor (59 mm) + anchor (75 mm)
plate (88 mm) + anchor (75 mm) + screws (M4 x 130 mm)
plate (39 mm) + self-tapping screw
plate (39 mm) + threaded plate
plate (39 mm) + welded stud bolts
plate (39 mm) + expanding corner pieces
Code
Description
7200
Mounting kit
720050
720051
720052
720053
720054
720055
720056
720060
720061
720062
720063
N.B. When ordering the mounting kit, check that the number of pieces is a multiple of the minimum pack.
IMPORTANT:
The tightening torque of the screws used in the mounting kit must be between 0.8 and 1 N·m.
1. PRELIMINARY INSPECTION (to be carried out by the installer)
No. of items in the pack
5
5
5
5
5
1
1
5
5
5
1
To Next Page
Loading...