What to do if there's an air leak at the lid gasket of my California Air Tools 1810C?
If you notice an air leak at the lid gasket, it could be due to a defective lid gasket or thumb screws that aren't tight enough. Try tightening the thumb screws first. If the leak persists, replace the lid gasket.
Why is the pressure dropping slowly on the gauge of my California Air Tools Industrial Equipment?
A slow pressure drop on the gauge usually means the valve seat in the regulator is either dirty or worn. The suggested solution is to replace the regulator.
How to fix air escaping from port on regulator cap of California Air Tools 1810C?
If air is escaping from the port on the regulator cap, the diaphragm in the regulator is likely broken or damaged. You should replace the regulator.
General| Model | 1810C |
|---|---|
| Type | Air Compressor |
| Power Source | Electric |
| Horsepower | 1.0 HP |
| Amperage | 8.5 Amps |
| Maximum Pressure | 120 PSI |
| Pump Type | Oil-Free |
| Number of Cylinders | 2 |
| Sound Level | 60 dBA |
| Motor Type | Induction |
| Voltage | 110V |
| Tank Size | 1.8 Gallons |
To Next Page