Need help?Do you have a question about the California Trimmer Mower and is the answer not in the manual?
Instructions for joining the top and bottom sections of the mower handle for Heavy Duty & Commercial models.
Details on connecting the clutch rod assembly and roller-lift rod to the handle.
Step-by-step instructions for draining old oil and refilling with new oil for the engine.
Adjusting the idler bearing position and ensuring the release bracket is above parallel.
Verifying 17-tooth sprocket and front sprocket on reel shaft are turning and aligned.
Checking if the chain and driveshaft are turning correctly.
Verifying 8-tooth sprocket, chain, and roller spinning for propulsion issues.
Procedure for adjusting the clutch spring tension by turning the inner nut.
Sequentially tightening nuts and bolts and rechecking alignment after adjustments.
Installing the clutch spring and set collar onto the drive shaft.
Installing wheels, spacers, and bearing holders onto the drive shaft assembly.
Installing components on the second side of the drive shaft, including wheels and bearings.
Installing the assembled drive shaft into the mower frame and completing final adjustments.
Using a spring compression tool to compress the clutch spring to a specific length.
Ensuring proper installation and free spinning of the final set of wheels and bearings.
Flowchart for diagnosing mower not propelling: engine off, disengage clutch, check manual reel turn.
Checking if engine sprocket, chain, bottom sprocket, and drive shaft are turning.
Verifying 17-tooth sprocket and chain are turning correctly.
Checking if the front sprocket is spinning on the reel shaft.
General| Brand | California Trimmer |
|---|---|
| Model | Mower |
| Category | Lawn Mower |
| Language | English |
To Next Page
