18
Site Preparation
Before you install any GigaSpire BLAST device, you need to consider the routing of the
power adapter cord and Ethernet cable(s) if used.
Power Cords
In order to complete the installation, a power cord is required:
GigaSpire Connectorized Power and Signal Cable - A 2-pin barrel connector to the local
AC power receptacle (Type A).
Coaxial Cables
Note that Coaxial cable connections are to be internal connections only. Outdoor
connections are not allowed.
Before you Begin
Before starting the installation process, check that the following conditions are met:
Ensure the site preparation steps are complete based on the model being installed.
Ensure that all components are on-site or readily available to complete the installation.
The customer is aware of your planned visit and will provide access to the inside of the
home.
Note: It is critical that you maintain the proper airflow in and around the unit. GigaSpire
BLAST devices are designed for surface mounting only. Do not install cabinetry or other
building material around the outside of the unit.
To Next Page
Loading...
