45
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
NTP
NTP management is used to setup the ONU time to be synchronized with network time
server.
The following table describes the parameters:
Parameters Description
Parameters Description
Enable NTP Server Enables or disables network time synchronization service
Current Time Display current system time
First Time Server Select first NTP server address. When select Customer Setting, user
needs to enter his own time server address.
Second Timer
Server
Select second NTP server address. When select Customer Setting,
user needs to enter his own time server address.
Interval Time Input the timing synchronization cycle interval
Time Zone Select the time zone the user is located in
After the configurations are done, click Save button to save it. Reboot the device to make the
modification to take effects. Refer to Reboot Device (on page 52) or press reset button to
reboot the system.
Figure 24: NTP
To Next Page
Loading...