7
Do not use wooden pick to clean the holes.
Be sure the burners are dry, as water lodged in the
burner parts might cause an uneven flame or interfere
with automatic lighting. (The burners can be heated in
the oven to dry them. Simply place the burners in the
oven on the oven racks and set the dial to 170°. Leave in
about 30 minutes.)
When replacing burners be sure they are in the correct
positions.
Relighting Top Pilots
If the top pilots should be extinguished while cleaning the
unit, relight them with a match as shown.
Before Calling for Service
Your cooktop is engineered to give you many years of
faithful service. It has been thoroughly tested before
leaving the factory.
If properly cared for, your built-in unit should not require
service. However, if your unit fails to perform properly,
we suggest you check the following before calling for
service.
Top burner will not light
Check the top pilots to be sure both are ignited. If not,
relight by lifting the main top and light with a match as
shown. For main top removal instructions, see page 6.
This unit can be converted from one type of gas to
another without additional conversion parts.
Instructions for conversion are contained in Installation
Instructions.
If service is required, contact an authorized service
center in your area at 1-800-NATLSVC (628-5782) inside
the U.S.A. and 319-622-5511 outside U.S.A.
To Next Page
Loading...