Simple Operation Guide for:
MONTBLANC & MONTBLANC PLUS
QUICK START
Listed below are a few quick steps to ensure you able to use the
installed Calthermic Montblanc radiator. All of the information
used below can be found in the instruction manual supplied
with every radiator.
Once the radiator has been fitted to the wall and
either plugged into a domestic three pin socket or
hard wired into a spur/flex outlet, by an adequately
qualified contractor, simply turn on the radiator.
Once switched on the main screen will flash, pressing
any button will stop the screen flashing.
This will now be the display, although newly out of
the box the radiator will be set at a temperature of
35 degrees. By pressing either the + or - buttons will
adjust the “call” temperature to your desired level. You can now operate the radiator
manually, using the ON button to bring the radiator in and out of standby mode. The
radiator will remember the temperature you set prior to being put in stand-by mode.
FIRST START
Calthermic
OperationGuide–MONTBLANC
Radiators
Listedbelowareafewquicksteps toensureyouabletousetheinstalled
radiator.Alloftheinformationusedbelowcanbefound
in the instructionmanual
MONTBLANC
suppliedwith
everyradiator.
FirstSwitchon
Oncetheradiatorhasbeenfittedtothewallandeitherpluggedintoadomesticthreepinsocketor
hardwiredintoaspur/flexoutlet,byanadequately qualifiedcontractor,simplyturnontheradiator.
Onceswitchedonthemainscreenwillflash,pressinganybutton
willstopthescreenflashing.
This will now be the display,alth ough newly out of the box the
radiator willbeset at a temper ature of 35 degrees. By pressing
either the + or – buttons will adjust the “call” temperature to
your desired level. You can now operate the radiator manually,
usingthe ON button to bring theradiator in andout of standby
mode.Theradiatorwillrememberthetemperatureyousetprior
tobeingputinstand‐bymode.
FIG 1
To Next Page
Need help?
General