Page 3
About this guide
This guide describes how to install the site equipment for PTP 670 Series links. Users of this guide must
follow good practice for outdoor radio installations.
In more advanced configurations, there may be one or two additional Ethernet interfaces connected to the
ODU: one to the SFP port (copper or optical) and one to the AUX port. For details of these configurations,
refer to the PTP 670 Series User Guide.
Version information
Document number and version: phn-4489_002v000 (June 2017).
User documentation
For full PTP 670 installation planning instructions and a list of components, download the PTP 670 Series
User Guide from: http://support.cambiumnetworks.com/files/ptp670
Waste Electrical and Electronic Equipment (WEEE)
For instructions on waste disposal of used products, refer to
http://www.cambiumnetworks.com/support/weee-compliance
EU Declaration of Conformity
Hereby, Cambium Networks declares that the Cambium PTP 670 Series Wireless Ethernet Bridge complies
with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of
conformity may be consulted at: http://www.cambiumnetworks.com/support/compliance/
Safety
To prevent loss of life or physical injury, observe the safety guidelines below. In no
event shall Cambium Networks be liable for any injury or damage caused during the
installation of the Cambium PTP 670. Ensure that only qualified personnel install a
PTP 670 link.
Power lines
Exercise extreme care when working near power lines.
Working at heights
Exercise extreme care when working at heights.
PSU
Always use the AC+DC Enhanced Power Injector to power the ODU. Failure to use a Cambium supplied
PSU could result in equipment damage and will invalidate the safety certification and may cause a safety
hazard.
To Next Page
Loading...
Need help?
General
