Cambium Networks PTP 820C Quick Start Guide

PTP 820C Quick Start Guide
Page 4
Installing the Unit
This Quick Setup guide provides instructions for installing and configuring a 2+0 dual-polarization direct-mount
pipe configuration using XPIC. These instructions can also be used for a direct-mount 1+0 configuration that can
later be upgraded to 2+0 with an additional activation key and minimal software configuration, no additional
hardware installation required.
Hardware configuration, including the type of mediation devices required, differs for different configurations. For
other configurations besides the 2+0 dual-polarization direct-mount XPIC configuration described in this Quick
Setup guide, refer to the PTP 820C Installation Guide.
When tightening the captive screws, use 20 Nm
torque for radio-antenna, radio-mediation device,
and mediation device-antenna connections. In order
to avoid misalignment, screws should be tightened
progressively.
Note
Do not remove the transparent
pressure window located on the
antenna interface.

Cambium Networks PTP 820C Specifications

General

Brand	Cambium Networks
Model	PTP 820C
Category	Network Router
Language	English