How to troubleshoot ping request timeout on Cambium Gateway?
If you are experiencing a timed out ping request on your Cambium Gateway, it means there's no IP connectivity. You should check your network configuration, including IP addresses, gateway address, subnet masks, and VLAN membership in the network equipment between your PC and the CMU.
Why is the CMU power indicator off on my Cambium PTP 800 Gateway?
If the CMU power indicator is off on your Cambium Gateway, the DC supply might be absent, or the CMU itself could be faulty. You should check the DC supply to the CMU.
What to do if Link Status shows Searching on Cambium PTP 800 Gateway?
If the Link Status attribute shows 'Searching' on your Cambium Gateway, ensure that the same channel bandwidth is configured for both ends of the link.
Why is the management port indicator off on my Cambium Gateway?
If the Management port indicator is off on your Cambium Gateway, it means the Ethernet link is down.
What does it mean if the copper data port indicator is off on Cambium Gateway?
If the Copper Data port indicator is off on your Cambium Gateway, the Ethernet link is down.
Why is the fiber data port indicator off on my Cambium Gateway?
If the Fiber Data port indicator is off on your Cambium Gateway, it means the Ethernet link is down.
What to do if Link Status shows Acquiring Registering on Cambium Gateway?
If the Link Status attribute shows 'Acquiring Registering' on your Cambium Gateway, check the System Summary for a Link Name mismatch alarm. If there is a mismatch, correct the Link Name so that it is identical at both ends of the link.
Why is the CMU status indicator red steady on my Cambium Gateway?
If the CMU status indicator is red steady on your Cambium Gateway, the CMU is out of service.
What does Power Supply Fault in RFU Status attribute mean for Cambium PTP 800 Gateway?
If the RFU Status attribute shows 'Power Supply Fault' on your Cambium Gateway, it means the CMU cannot power the RFU. Check the connections.
What does No Response in RFU Status attribute mean for Cambium Gateway?
If the RFU Status attribute shows 'No Response' on your Cambium Gateway, the RFU is not responding to management messages from the CMU. Check the connections.
General| Modulation | QPSK, 16QAM, 64QAM |
|---|---|
| Power Supply | 48V DC |
| Channel Bandwidth | 5 MHz, 10 MHz, 20 MHz, 30 MHz, 40 MHz |
| Interface | Ethernet |
| Product Category | Point-to-Point |
| Range | Up to 125 miles (201 km) |
To Next Page