What to do if my Cambro Camtherm CHPL100 Commercial Food Equipment unit does not roll smoothly?
If your Cambro Commercial Food Equipment unit isn't rolling smoothly, there are a couple of things you can check: * First, examine the casters for any debris and clean them thoroughly. * Second, the caster axles and bearings might need lubrication. Clean them and then apply WD-40 or a similar spray lubricant.
What to do if my Cambro Commercial Food Equipment unit powers on but does not heat?
If your Cambro Commercial Food Equipment unit powers on but doesn't heat, call for service. A technician needs to check the thermostats, heater controller, sensor, and heating elements.
Why is my Cambro Camtherm CHPL100 unit overheating?
If your Cambro Commercial Food Equipment unit is overheating, call for service. A technician needs to open the back cover and ensure that the fan wiring is properly and securely connected. If the wiring is properly and securely connected, the fan should be replaced.
What to do if my Cambro Camtherm CHPL100 Commercial Food Equipment unit powers on and heats up but never reaches the set-point operating temperature?
If your Cambro Commercial Food Equipment unit powers on and heats up but never reaches the set-point operating temperature, call for service. A technician needs to ensure both elements are securely connected and operating properly and inspect all functions of the controller.
What to do if my Cambro Commercial Food Equipment unit powers on but does not display temperature?
If your Cambro Commercial Food Equipment unit powers on but does not display temperature, call for service. A technician needs to inspect all functions of the controller and check the controller relay.
What to do if my Cambro Camtherm CHPL100 Commercial Food Equipment unit plugged in, power confirmed, turn unit on and nothing happens?
If your Cambro Commercial Food Equipment unit is plugged in, power is confirmed, you turn the unit on, and nothing happens, call for service. A technician needs to open the back cover and ensure that all wiring is properly and securely connected.
Why are the plates too hot in my Cambro Camtherm CHPL100 unit?
If the plates in your Cambro Commercial Food Equipment unit are too hot, check to ensure the unit is set at a max of 175°F (79.4°C). If the unit continues to heat higher than 175°F (79.4°C), call for service.
Why are the plates not hot enough in my Cambro Camtherm CHPL100 unit?
If the plates in your Cambro Commercial Food Equipment unit are not hot enough, check to make sure the unit is set to at least 140°F (60°C). If the unit continues to not get hotter than 140°F (60°C), call for service.
How to fix a Cambro Commercial Food Equipment self-leveling dispenser that does not glide smoothly?
If your Cambro Commercial Food Equipment self-leveling dispenser isn't gliding smoothly, here's what you can do: * Inspect all springs for wear, over-extension, or detachment. Replace worn springs or reattach existing springs that have come loose. * Clear any debris from the dispenser guides, following the maintenance/cleaning instructions in the manual. * Thoroughly clean the dispenser uprights, also following the maintenance/cleaning instructions in the manual.
Critical safety guidelines for operation, grounding, and avoiding electrical hazards.
Guidance for when plates are too hot, including set point checks and calling for service.
Troubleshooting for plates not reaching desired temperature, checking set points and heating system.
Diagnosis for units that power on but do not heat, covering thermal overload and faulty components.
Troubleshooting for a unit that is plugged in but shows no sign of life, checking wiring and controller.
General| Capacity | 9.5 qt |
|---|---|
| Dimensions | 16 1/2" x 12 3/4" x 8 1/2" |
| Weight | 12.34 lbs |
| Temperature Range | Maintains hot or cold temperatures |
| Insulation | Foam |
To Next Page
