Need help?Do you have a question about the CAME BPT MTMA/GSM and is the answer not in the manual?
General| Brand | CAME BPT |
|---|---|
| Model | MTMA/GSM |
| Category | Control Unit |
| Language | English |
Preparatory steps before device setup, including SIM card and power checks.
Procedure for powering on the module and initial status indicators.
Method to verify GSM network registration using the PROG button.
How to increase or decrease the speaker volume during a conversation.
How to adjust the microphone sensitivity during a conversation.
Explains the structure and syntax for sending programming commands via SMS.
How to change the device's access password via SMS.
Assigning phone numbers to specific groups for call management.
Linking user groups to entry panel call buttons.
Assigning names to user groups for display on modules.
Linking keypad codes to groups for specific actions.
Enabling specific phone numbers to activate door-release or relay outputs.
Enabling keypad codes to activate door-release or relay outputs.
Removing all data associated with a specific group.
Removing a phone number and its linked actions.
Removing keypad codes linked to user IDs.
Resetting all stored telephone numbers and group associations.
Removing all keypad codes associated with activations.
Setting call duration and the time before moving to the next number.
Configuring the duration for door-release and auxiliary relay activation.
Setting the colour and brightness of the entry panel keypad.
Defining the operational role of terminals I1 and I2.
Selecting the display language for MTMDY and MTMBFVS modules.
Configuring colour, brightness, stand-by, and search settings for display modules.
Setting the audio input and output levels for the entry panel.
Configuring audio feedback for key presses, lock activation, and messages.
Checking the current signal quality of the GSM module.
Initiating a call back from the module to the sender of an SMS.
Querying the firmware version of specific modules installed in the system.
To Next Page