CAME FLUO-SL - Page 9

FA00150-EN v.7 - 06/2017
9
CAME S.p.A.
4.4 PROFILES AND GASKET CUTTING MEASURE
All the aluminium profiles and gaskets needed for the realization of the FLUO-SL automations must be cut 20 mm shorter
than the maximum length of the automation (Ld – 20), also including the plastic end caps.
Ref.
Code
Description
FLUO-SLB Automation
311
001FL-CSG4
Drive unit profile raw aluminum 4020 mm
001FL-CSG6
Drive unit profile raw aluminum 6620 mm
104
001FL-RA4
Rail profile anodized aluminum 4020 mm
001FL-RA6
Rail profile anodized aluminum 6620 mm
102
001FL-CTA4
Cover profile anodized aluminum 4020 mm
001FL-CTA6
Cover profile anodized aluminum 6620 mm
107D
001FL-G04
Cover gasket 40 m
165
001FL-G05
Cover-Leaf gasket 40 m
Ref.
Code
Description
FLUO-SL Automation
100
001FL-MA4
Support profile anodized aluminum 4020 mm
Support profile anodized aluminum 6620 mm
101
001FL-MA6
Drive unit profile anodized aluminum 4020 mm
Drive unit profile anodized aluminum 6620 mm
104
001FL-CSA4
Rail profile anodized aluminum 4020 mm
Rail profile anodized aluminum 6620 mm
102
001FL-CSA6
Cover profile anodized aluminum 4020 mm
Cover profile anodized aluminum 6620 mm
107B
001FL-RA4
Drive unit gasket 40 m
107C
001FL-RA6
Support gasket 40 m
107A
Rail gasket 40 m
107D
Cover gasket 40 m
165
001FL-CTA4
Cover-Leaf gasket 40 m