CAME RIOPH8WS - Saving Procedure; Saving Transmitter and Receivers; Resetting Procedure; Battery Replacement

FA00948M4A - 11/2017FA00948M4A - 11/2017
- Make the necessary functional checks (see the manual
FOR the RIOCT8WS OR THE RIOCN8WS).
- Shut the casings by latching the top of the cover and
fastening it with the supplied screw ⑥.
Saving
Fit the batteries into all accessories that will be saved.
⚠After three minutes, the devices shift into stand-by
mode; to reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are fl ashing red
simultaneously, otherwise do a reset (see THE RESETTING
PROCEDURE).
SAVING T1
Press, for one second, the T1 button on the RIOPH8WS
card: the CH1 and CH2 LEDs will fl ash red in alternation.
Press, for one second, the PROG button on the RIOCN8WS
card or the RIOCT8WS card: the WIRELESS LEDs, on the
RIOCN8WS or the RIOCT8WS card, will switch to from
fl ashing to o , and the CH1 LED on the RIOPHWS card will
fl ash blue once and then switch o .
SAVING T2
Press, for one second, the T2 button on the
RIOPH8WS card: the CH1 and CH2 LEDs will fl ash red in
alternation. Press, for one second, the PROG button on the
RIOCN8WS card or the RIOCT8WS card: the WIRELESS
LEDs, on the RIOCN8WS or the RIOCT8WS card, will
switch to from fl ashing to o , and the CH1 LED on the
RIOPHWS card will fl ash blue once and then switch o .
⚠ To interrupt the SAVING procedure, press the RESET
BUTTON.
Resetting procedure
☞THE RESETTING procedure must be done on the both
the receiver and the transmitter.
☞If you replace any device on the system, you will have
to RESET and then again SAVE all of the system devices.
- Keep pressed the T2 button on for about 10 seconds on
the RIOPH8WS card, until the CH1 and CH2 LEDs fl ash red.
Batteries
⚠ Only replace with the same or equivalent battery
type.
⚠The batteries must be replaced by a specialized
assistance center and only by qualifi ed technicians.
⚠ Keep the batteries away from children's reach.