To Next PageTo Next Page
Need help?Do you have a question about the CAME ZL371 and is the answer not in the manual?
General| Brand | CAME |
|---|---|
| Model | ZL371 |
| Category | Computer Hardware |
| Language | English |
Details terminal boards for transformer, motor, accessories, and antenna connections.
Identifies line fuses, accessories fuse, and control board fuse for protection.
Describes connectors for RF/RSE cards, display, and programming buttons.
Illustrates the wiring of the red cable during electrical connections.
Illustrates the wiring of the white cable during electrical connections.
Illustrates the wiring of the black cable during electrical connections.
Function and contact type for the STOP button, stopping boom and excluding auto-closing.
Details OPEN ONLY, PARTIAL OPENING, and CLOSE ONLY control device functions.
Specifies the antenna connection using an RG58 cable.
Describes additional lights and beacons for maneuver area illumination and signaling.
Explains the warning light that notifies users of the operator status.
Details the signaling behavior of the rope light during operations.
Details standard and safety test connections for DELTA photocells.
Details sleep mode and safety test connections for DIR/DELTA-S photocells.
Details sleep mode and safety test connections for DXR/DLX photocells.
Explains the functions of ESC, <>, and ENTER buttons.
Provides initial steps for commissioning and operation.
Configures the operator's total stop feature, excluding automatic closing.
Enables testing of connected photocells for correct operation after each command.
Manages operator movement control based on the release of a control device.
Sets the time delay for automatic closure after reaching the opening end point.
Adjusts the activation time for the beacon before each maneuver.
Sets the gearmotor working time for opening and closing operations.
Adjusts the speed for opening and closing operations, with recommendations for accessories.
Adjusts obstacle detection sensitivity during the gate travel.
Adjusts obstacle detection sensitivity during the slowdown phase.
Configures functions for the board connected to the RSE1 connector.
Allows sharing of parameters between Master and Slave barriers.
Reduces photocell power consumption when they are in standby.
Registers new users and assigns specific functions to them.
Details the process for removing registered users from the system.
Selects the type of radio coding for transmitters controlling the operator.
Restores the operator's settings to their original factory defaults.
Connects two electronic boards using UTP CAT 5 cable for paired operation.
Programming operations for paired control boards, performed on the MASTER unit.
Illustrates STEP-BY-STEP and PARTIAL OPENING command modes for paired barriers.
Connects two electronic boards using UTP CAT 5 cable for alternate operation.
Programming operations for alternate control boards, performed on the MASTER unit.
Details the ONLY OPEN command on barrier A, with barrier B opening upon A's closure.
Details the PARTIAL OPENING command on barrier B, with barrier A opening upon B's closure.
Details the STEP-BY-STEP command on barrier A or B for emergency opening.
Key for understanding the meaning of wired safety device active warnings (C<n>).
Lists common error messages and their potential causes for troubleshooting.
