18
DEUTSCHENGLISH
DMX
ITALIANO
POLSKI
ESPAÑOL
FRANCAIS
Settings
Disp Rev = Rotate display No No display rotation
Yes Display is rotated by 180°
(e.g. for overhead installation)
Disp Back = Display lighting Off Deactivates after approximately 30
seconds of inactivity
On On permanently
Sig Fail = Operating status
with DMX signal
fault
Hold Last command is retained
Black Activates blackout
User 1 User Color 1 is activated
Sound = Sets music
control
Last Color is retained until next impulse
Off Color expires after a moment, until next
impulse
PWM = LED PWM
frequency
650 Hz,
1530 Hz,
2150 Hz,
4000 Hz
Select LED PWM frequency
Calibration
(CLROOT-
PAR4)
= Color calibration Red, Green,
Blue, White
Individual color calibration. Cross-mode
brightness setting of the 4 LED groups
RGBW with values from 0 to 255
Calibration
(CLROOT-
PAR6)
= Color calibration Red, Green,
Blue, White,
Amber, UV
Individual color calibration. Cross-mode
brightness setting of the 6 LED groups
RGBWA+UV with values from 0 to 255
IR Remote = Activate or deacti-
vate control by IR
remote control
On IR remote control activated
Off IR remote control deactivated
Reset = Reset settings Factory Reset to factory settings: Perform
reset with ENTER, cancel with MENU
Preset A Reset to Preset A: Perform reset with
ENTER, cancel with MENU
Preset B Reset to Preset B: Perform reset with
ENTER, cancel with MENU
Preset C Reset to Preset C: Perform reset with
ENTER, cancel with MENU
Edit Preset = Store all system
settings in 3
individual presets
Preset A Store with ENTER
Preset B Store with ENTER
Preset C Store with ENTER
Service = For service purposes only
To Next Page
Loading...
