4.2.2 Configure data logger
1. Connect to your data logger by using Device Configuration Utility.
2. On the PPP tab, set Config/Port Used to CS I/O SDC8 or RS-232, depending on how you
are connected to the data logger.
3. Verify the Modem Dial String setting is blank.
4. If connecting through RS-232, on the Comport Settings tab, set RS232 BaudRate to 115200
Fixed.
5. On the Cellular tab, enter the APN provided by your cellular provider.
CELL200-Series 4G LTE Cellular Module 16
To Next Page
Loading...
