l 9600 for CR10X, CR10X-PB, CR510, CR510-PB, CR23X, CR23X-PB, and CR200
(X) series data loggers
l 8 data bits, 1 stop bit, no parity
If connecting to RS-232 port:
Null Modem Cable (9 pin, male-to-male) — connects the module to the CR1000X series,
CR300 series, CR1000, CR3000, CR800 series, and CR200(X) series RS-232 port.
CPI/RS-232 RJ45 to DB9 Cable — connects the module to the CR6 series or CR1000X
series CPI/RS-232 port.
l Antenna — the following antennas are available from Campbell Scientific. Contact
Campbell Scientific for help in determining the best antenna for your application.
o
2 dBd 4G/3G Omnidirectional Antenna: An omnidirectional antenna with mounting
bracket that is ideally suited for use with 4G and 3G cellular gateways. The mounting
bracket attaches to a mast or crossarm, and it serves as the antenna ground plane.
The antenna has an N type (female) threaded permanent stud for easy mounting to
the included bracket or through an enclosure wall. A coaxial cable, sold separately, is
required to connect this antenna to the inline surge suppression or module antenna
jack. The antenna includes a mount/U-bolt assembly for attaching the antenna to a
mast, post, or crossarm up to 3.8 cm (1.5 in) in diameter.
o
8 dBd Yagi Wideband Antenna: A higher gain antenna that should be “aimed” at the
service provider antenna. It covers both the 800-MHz band and the 1.9-GHz band.
The antenna comes with bracket/U-bolt assembly for attaching the antenna to a
mast or post. A coaxial cable, sold separately, is required to connect this antenna to
the inline surge suppression or module antenna jack. This antenna is recommended
CELL200-Series 4G LTE Cellular Module 24
To Next Page
Loading...
