Campbell CELL200 Series - Page 74

CRBasic Example 2: Settings configuration and status retrieval
DataTable(CELL_DIAGNOSTICS, True, -1)
Sample(1, cell_todays_usage, FP2) 'or
Sample(1, Settings.CellUsageToday, FP2)
Sample(1, cell_yesterdays_usage, FP2) 'or
Sample(1, Settings.CellUsageYesterday, FP2)
Sample(1, cell_this_months_usage, FP2) 'or
Sample(1, Settings.CellUsageMonth, FP2)
Sample(1, cell_last_months_usage, FP2) 'or
Sample(1, Settings.CellUsageLastMonth, FP2)
Sample(1, cell_rssi, IEEE4) 'or
Sample(1, Settings.CellRSSI, IEEE4)
Sample(1, cell_info, String) 'or
Sample(1, Settings.CellInfo, String)
Sample(1, cell_ip_address, String)
Sample(1, cell_rsrp, IEEE4) 'or
Sample(1, Settings.CellRSRP, IEEE4)
Sample(1, cell_rsrq, FP2) 'or
Sample(1, Settings.CellRSRQ, FP2)
Sample(1, cell_ecio, FP2) 'or
Sample(1, Settings.CellECIO, FP2)
Sample(1, cell_status, String) 'or
Sample(1, Settings.CellStatus, String)
Sample(1, cell_state, String) 'or
Sample(1, Settings.CellState, String)
EndTable
DataTable(TEST_DATA, True, -1)
DataInterval(0, 5, Min, 10)
Minimum(1, battery_voltage, FP2, True, False)
Sample(1, panel_temperature_c, FP2)
EndTable
'Main Program
BeginProg
'set up attached cell2xx module via CRBasic programming.
SetSetting("CellEnabled", True)
'Cell modem is enabled, True = enabled, False = disabled
SetSetting("CellAPN", "****.****")
'Replace *s with APN assigned by cellular provider
SetSetting("CellPwrStartTime", 1440)
'Automated start-up schedule. Setting is in minutes (into day).
'1440 = Always on. 15 = 00:15 hours, 180 = 03:00 hours, 1380 = 23:00 hours
SetSetting("CellPwrDuration", 0)
'How long the modem is to stay online after it hits it Start Time.
'Setting is ignored if CellPwrStartTime is set to 1440
SetSetting("CellPwrRepeat", 0)
CELL200-Series 4G LTE Cellular Module 61