- 13 -
GB
- Poor gas supply
- Regulator not operating properly
- Pipe, valve, venturi tube or burner holes
obstructed
goes out
- Check that gas is present
- Check the pipe connection
- Contact your servicing agent.
-
New cylinder may contain air. Allow the
stove to operate and the fault will clear itself
- Residual water, following the washing of
the burner caps
- Contact your servicing agent.
- The venturi is obstructed (possibly
cobwebs). Clean the venturi.
- Contact your servicing agent.
Flame at the injector
- The cylinder is almost empty
- Change the cylinder and the fault will
clear itself
- Contact your servicing agent.
Burning leak around a union
- Shut off the gas supply immediately
- Leaking union: tighten nuts or change pipe
- Contact your servicing agent.
- Injector or venturi tube obstructed
- Contact your servicing agent.
- Defective valve
- Shut down the stove
- Contact your servicing agent.