What to do if Camplux Water Heater water not hot enough?
If your Camplux Water Heater isn't producing water hot enough, the temperature setting might be too low. Increase the temperature setting. Also, check that the gas valve is fully opened.
How to fix Camplux CA528 with not enough hot water?
If your Camplux Water Heater isn't providing enough or any hot water, start by checking if the water shutoff valve is fully opened. Make sure the hot water faucet is completely open, as the burner shuts off if the water volume is too low. Also, check for frozen pipes and ensure the unit is turned 'ON' via the remote. Verify that electricity and water supply are adequate, and the temperature setting isn't too low. If applicable, inspect the mixing valve for malfunctions. Finally, check the remote control for any error codes and consult the error code instructions. If needed, contact a dealer for service.
Why is Camplux Water Heater water too hot?
If the water from your Camplux Water Heater is too hot, the temperature setting might be too high; try decreasing it. Also, check that the water shutoff valve is fully opened. If only a small amount of water has been heated, allow more water to flow. Lastly, a clogged water filter can cause this issue, so clean it with a toothbrush.
Why does Camplux Water Heater fan continue to rotate after closing the hot water faucet?
The fan continues to rotate after the hot water faucet is closed on your Camplux Water Heater to purge unburned gas for 10-15 seconds. This is normal operation, so there is no need to call for service. Check for any error codes.
Steps to take if a gas leak is suspected.
Important safety warnings and their definitions.
Emphasizes proper installation to avoid fire, explosion, or asphyxiation.
Explains the risks of flammable vapors igniting from the burner.
Chart showing burn times at different water temperatures.
Recommends lower temperature settings for vulnerable individuals.
Cautions regarding propane gas, its heavier-than-air nature.
Detailed steps to follow in case of a gas leak.
Details on air supply needed for combustion and ventilation.
Warning against storing or using flammable liquids near the heater.
Minimum pressure and flow rate needed for proper operation.
Warning against converting gas types; requires professional connection.
Details on approved piping material and gas shut-off valve installation.
Requirements for pressure rating and BTU/Hr rating of the relief valve.
Hazards of improper venting leading to death, injury, explosion, or fire.
Clearances for vent termination in US installations.
Clearances for vent termination in Canadian installations.
Importance of proper grounding and wiring for safety.
Warnings and checks before operating the water heater.
Procedures for turning on the water heater and initiating operation.
How to adjust and set the water temperature for desired output.
Safety precautions when manually operating the relief valve.
Safety warnings for draining the water heater to prevent damage and injury.
Possible causes and solutions for lack of hot water.
Possible causes and solutions for insufficient water temperature.
General| Type | Tankless Water Heater |
|---|---|
| Power Source | Propane |
| Heating Capacity/Flow Rate | 5.28 GPM |
| Installation | Outdoor |
| Material | Stainless Steel |
| Ignition | Electronic |
| Voltage | 3V DC |
To Next Page
