1 IMPORTANT. Read these instructions for use carefully.
2 Check for gas leaks with soapy water
3 Gas appliances must only be used in well ventilated areas
1 IMPORTANT. Read these instructions for use carefully.
2 Check for gas leaks with soapy water
3 Gas appliances must only be used in well ventilated areas
Gas valve levers in the
OFF position.
Gas valve levers in the high
flame position.
LIGHTING INSTRUCTIONS
TO LIGHT WITHOUT POT IN POSITION
1. Turn on the gas supply at the cylinder.
2. Using a long match or gas lighter,
locate flame next to the inner burner
ring and ensure hands are clear of the
burner.
3. Slowly rotate the corresponding gas
valve lever to high flame position.
4. If burner ring does not ignite, close
the gas valve lever, then wait for gas
to dissipate before re-attempting to
light the burner.
5. Once lit, observe the burner ring to
check all ports are alight.
6. To light all burner rings, follow the steps above and light
each ring individually. Light the inner ring first, then work
your way outwards.
TO LIGHT WITH FULL WIDTH POT IN POSITION
1. Follow steps 1 to 5 above, but during
step 2, light the outer burner ring.
2. To light all other rings, open the gas
valves in sequence, progressively
towards the inner burner ring.
TO TURN OFF THE APPLIANCE
1. Turn the gas cylinder valve off, then wait
for the flame to go out.
2. Turn all the appliance control valves off.
IMPORTANT! CHECKING THE FLAME
NOTE: Adjustments below are only avaliable for models without fixed aeration discs.
BAD FLAME
If your burner is producing a bad ame check
the aeration disc setting. Never allow the burner
to operate with a bad ame.
AERATION DISCS
Adjust the aeration discs until you
achieve a good ame as shown
below.
AERATION DISCS
GOOD FLAME
To Next Page