Filter Replacement Instructions
Prefilter Replacement
1. Turn the unit off and unplug it.
2. Remove the used prefilter and carefully discard
it in a plastic bag.
3. Line up the seam in the prefilter with the
receptacle at the back of the unit. Pull the new
prefilter over the unit so it snugly covers the
screen.
4. Plug the unit in and turn it on.
V.O.C. Filter Replacement
1. Turn the unit off and unplug it.
2. Turn the unit up-side down. With one hand
holding the HEPA cartridge, pull the motor/fan
housing off.
3. Remove the used V.O.C. filter and carefully
discard it in a plastic bag.
4. Roll the new V.O.C. filter into a cylinder smaller
than the size of the opening in the HEPA
cartridge. Insert the V.O.C. filter all the way into
the well and spread it open against the HEPA
filter.
5. Sit the motor/fan housing right side up and seat
the gasket in the groove.
6. Place the HEPA cartridge on the motor/fan
housing and align the plugs in the cartridge with
the holes in the housing.
7. Once the holes are aligned press firmly on the
top of the cartridge to secure it to the housing.
8. Plug the unit in and turn it on.
HEPA Cartridge Replacement
1. Turn the unit off and unplug it.
2. Turn the unit up-side down. With one hand holding
the HEPA cartridge, pull the motor/fan housing away.
Discard the cartridge in a plastic bag.
3. Sit the motor/fan housing right side up and seat the
gasket in the groove.
4. Place the HEPA cartridge on the motor/fan housing
and align the plugs in the cartridge with the holes in the
housing.
Once the holes are aligned press firmly on the top of the
cartridge to secure it to the housing.
5. Plug the unit in and turn it on.
Specifications
DIMENSIONS: 8.5" D 7.5”H
WEIGHT: 5 lbs.
AIR FLOW (C.F.M.): 20 and
40
SERVICE AREA: 75-150
sq.ft. Based on 2 to 4 air
change-overs per hour,
recommended for people
with sensitivities
LOWER CONSUMPTION:
4.5 Watts
HEPA SURFACE AREA: 19
sq.ft.
CLASSIFICATION
• Portable HEPA (High
Efficiency Particulate Air)
100% Sealed Air Cleaning
Device
• U.L. and C.S.A. approved
INTEGRATED AIR SEAL (TOP &
BOTTOM)
STAGE 1: WASHABLE PREFILTER
STAGE 2: HEPA FILTER REMOVES
99.97% OF PARTICULATES FROM
0.3 MICRONS IN SIZE
19 SQ. FT SURFACE AREA
LASTS UP TO 5 YEARS
STAGE 3: V.O.C. FILTER
POWERFUL, EFFICIENT
MOTOR/FAN
USES ONLY 4.5 WATTS
C.S.A. AND
N.T.R.L.(U.L.)APPROVED
CLEAN AIR OUTFLOW
TWO SPEED OPERATION
MATERIALS: 24 gauge cold rolled
steel
FINISH: Powder coated baked
enamel
COLOR: Black or White
INTAKE (Upper Section)
Three-stage filter cartridge:
Integrated HEPA filter cartridge
with washable prefilter and V.O.C.
Filter
OUTFLOW (Lower Section)
330 degree perimeter outflow
MOTOR/FAN
• Designed for continuous
operation
• Run tested for 35,000 hours
CONTROL: 3-position, 2-speed
switch
Limited Warranty
The motor/fan in this CanAm Wellness product is warranted by
CanAm Wellness Corporation to the original retail purchaser for FIVE
(5) YEARS from the date of purchase. All other components (except
filters) are warranted for ONE (1) YEAR. CanAm Wellness will repair
or replace at its option the component(s) which upon inspection by an
authorized CanAm Wellness dealer proves to have failed in normal
use, due to defects in material or workmanship, or, at its option, to
replace the unit. Operations other than those recommended in this
manual or at voltages other than that specified on the unit, or any
attempts by unauthorized personnel to service or modify the unit will
void the warranty.
1-877-523-7800
WARRANTY SERVICE IS AVAILABLE BY BRINGING YOUR UNIT, OR
SENDING IT POSTAGE PREPAID, WITH PROOF OF PURCHASE TO THE
VENDOR WHO SOLD YOU THE UNIT
To Previous Page
Loading...