Need help?Do you have a question about the Canadian Solar HiKu7 and is the answer not in the manual?
General| Temperature Coefficient of Pmax | -0.34 % / °C |
|---|---|
| Cell Type | Monocrystalline |
| Frame Material | Anodized aluminum |
| Operating Temperature | -40°C to +85°C |
| Maximum System Voltage | 1500 V |
For roof projects, unpack modules individually, do not carry the whole package onto the roof.
For all projects, it is recommended to strictly follow the unpacking steps provided.
Place pallets on flat ground; ground inclination should not exceed 4 degrees.
Ensure correct pallet direction and use an anti-tipping system for module safety.
Detailed process for making anti-tipping brackets using two wooden beams.
Carefully tear off all shrink-wrap film covering the box, wearing gloves for safety.
Cut outer packing straps, leaving the bottom two uncut, ensuring personal safety.
Remove upper wood protection and top cardboard cover, keeping the lower protection.
Tear off the upper carton along the pre-cut line to access the modules.
Cut all inner straps, including the hidden bottom belt, but not the outer ones.
Tear off high-viscosity anti-tipping tape one by one to remove modules individually.
Two workers extract modules using both hands, moving them parallel to the short side.
Cut the two anti-tipping nylon ties before removing the last module.
Install modules immediately; sort packaging for recycling. Temporary storage methods detailed.
To Next Page
