8
Oil Do not ingest liquids
The Canaline marine propulsion package is supplied with 2 dipsticks, one for the
engine and one for the gearbox. Ensure dipsticks are returned and secure after
checking. If not, oil leaks can cause infection when touched. Do not remove
dipsticks whilst engine is running, as this can cause oil to blow out. All oil must be
removed from the skin to prevent infection.
Scalding
Do not remove Pressure Cap when Hot
An engine running under load will have a closed circuit fresh water temperature of
71° to 85°C. The pressure cap on the top of the header tank must not be
removed when the engine is running. It should only be removed when the engine
is stopped and has cooled down.
Transportation/Lifting
Engines are supplied on transportable pallets. Lifting eyes on engines are used
for lifting engine and gearbox assembly only, not the pallet and associated kit.
GENERAL DECLARATION
This machinery is not intended to be put into service until it has been incorporated
into or with other machinery. It is the responsibility of the purchaser/installer/owner,
to ensure that the machinery is properly guarded and that all necessary health and
safety requirements, in accordance with the laws of the relevant country, are met
before it is put into service.
Note: Recreational Craft
Where applicable, the purchaser/installer/owner and operator must be responsible for
making sure that Directive 2013/53/EU is complied with.
To Next Page
Loading...
